Knowledge Base

KB Home | Search | Glossary | Ask Question |

English

How do I reset the DST100 total distance log?

Article Number: 192 | Rating: Unrated | Last Updated: Tue, Jun 17, 2008 4:24 PM

The DST100 total distance log is not resettable. The total distance log indicates the total distance traveled since the DST100 was purchased and installed in the vessel.

Attachments

Attachments

There are no attachments for this article.

Related Articles

How long is the cord that is attached to the DST100?

Viewed 2984 times since Tue, Jun 17, 2008

What type of information can be viewed on Maretron’s display products, and what products are required to generate the data to be displayed?

Viewed 25598 times since Tue, Oct 25, 2011

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Speed Calibration..."; what is this?

Viewed 3083 times since Sun, Jun 22, 2008

Why is the DST110 Speed Through Water (STW) reading different from the Speed Over Ground (SOG) reading?

Viewed 46683 times since Tue, Jun 17, 2008

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Clear Speed Calibration:"; what is this?

Viewed 3166 times since Sun, Jun 22, 2008

How do I clear the DST100 Speed Through Water (STW) calibration using Maretron’s DSM150, DSM200, or DSM250 display?

Viewed 3906 times since Mon, Aug 4, 2008

What is the minimum Speed Through Water (STW) that the DST100 will measure?

Viewed 3636 times since Sun, Jun 22, 2008

What are the voltage specifications for each Maretron device?

Viewed 8314 times since Thu, Dec 22, 2011

How do I display the DST100 transducer offset on Maretron’s DSM150, DSM200, or DSM250 display?

Viewed 3454 times since Tue, Jun 17, 2008

How do I display the DST100 Speed Through Water (STW) on Maretron’s DSM150, DSM200, or DSM250 display?

Viewed 2925 times since Tue, Jun 17, 2008

Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.