Knowledge Base

KB Home | Search | Glossary | Ask Question |

English

With regards to the DST100, what is the difference between the trip log and the total log?

Article Number: 191 | Rating: Unrated | Last Updated: Thu, Jul 16, 2015 9:59 PM

Trip log is the distance traveled since the last reset and can be used to record how far you go on a particular trip. Total log is the total distance the vessel has traveled since the DST100 was purchased and installed on the vessel. You can reset the trip log at any time using a DSM150, DSM200, or DSM250, but you can't reset the total log.

Attachments

Attachments

There are no attachments for this article.

Related Articles

How do I reset the DST100 total distance log?

Viewed 2327 times since Tue, Jun 17, 2008

How do I measure dead rise angle?

Viewed 4038 times since Sun, Jun 22, 2008

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Transducer Depth Offset:"; what is this?

Viewed 3653 times since Mon, Jun 25, 2012

Why doesn’t the DST100 work when it is out of the water?

Viewed 2409 times since Sun, Jun 22, 2008

How do I clear the DST100 Speed Through Water (STW) calibration using Maretron’s DSM150, DSM200, or DSM250 display?

Viewed 3584 times since Mon, Aug 4, 2008

What type of information can be viewed on Maretron’s display products, and what products are required to generate the data to be displayed?

Viewed 24629 times since Tue, Oct 25, 2011

What is the maximum dead rise angle that the DST100 can cope with?

Viewed 2406 times since Sun, Jun 22, 2008

How do I display the DST100 water depth on Maretron’s DSM150, DSM200, or DSM250 display?

Viewed 3320 times since Tue, Jun 17, 2008

Why is the DST110 Speed Through Water (STW) reading different from the Speed Over Ground (SOG) reading?

Viewed 45000 times since Tue, Jun 17, 2008

What information does the DST100 provide?

Viewed 2745 times since Tue, Jun 17, 2008

Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.