Knowledge Base

KB Home | Search | Glossary | Ask Question |

English

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Trip log:"; what is this?

Article Number: 189 | Rating: Unrated | Last Updated: Thu, Jul 16, 2015 9:58 PM

Maretron's DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Trip Log:", which is used to reset the trip log information back to zero.

Attachments

Attachments

There are no attachments for this article.

Related Articles

What firmware changes have taken place on the Maretron DSM410?

Viewed 1807 times since Tue, Jul 14, 2020

How do I set a "Device Instance" for a Maretron sensor using the DSM250?

Viewed 3827 times since Tue, Sep 1, 2009

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a J2K100 configuration setting called "NMEA 2000 PGN Enable/Disable..."; what is this?

Viewed 3437 times since Thu, Jan 14, 2010

Can Maretron devices be displayed on a Raymarine Seatalk NG network?

Viewed 10763 times since Wed, Feb 25, 2015

How do I calibrate the SSC200 rate of turn using Maretron’s DSM150, DSM200, or DSM250 display?

Viewed 2896 times since Thu, Jun 19, 2008

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Speed Calibration..."; what is this?

Viewed 3124 times since Sun, Jun 22, 2008

How do I display the J2K100 generator average line-line AC voltage on Maretron’s DSM150 or DSM250 display?

Viewed 3698 times since Thu, Jan 14, 2010

How do I reset the TLA100 to send the factory default messages (or PGNs)?

Viewed 2752 times since Fri, Jun 20, 2008

How much electrical current does the DST100 use?

Viewed 2418 times since Tue, Jun 17, 2008

How do I configure a channel on the SIM100 using Maretron’s DSM250 Display?

Viewed 2782 times since Tue, Sep 1, 2009

Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.