Knowledge Base

KB Home | Search | Glossary | Ask Question |

English

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Clear Speed Calibration:"; what is this?

Article Number: 177 | Rating: Unrated | Last Updated: Thu, Jul 16, 2015 9:25 PM

Maretron's DSM200 and DSM250 displays have a DST100 configuration setting called "Clear Speed Calibration:", which is used wipe out or clear the multiplier used by the displays to adjust the Speed Through Water (STW) value coming from a DST100.

Attachments

Attachments

There are no attachments for this article.

Related Articles

How do I measure dead rise angle?

Viewed 2948 times since Sun, Jun 22, 2008

How do I display the GPS100 Speed Over Ground (SOG) using Maretron’s DSM150, DSM200, or DSM250 display?

Viewed 1962 times since Tue, Jun 17, 2008

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a GPS100 configuration setting called "Cold Start GPS Engine"; what is this?

Viewed 2150 times since Tue, Jun 17, 2008

How do I set the J2K100 configuration setting called "NMEA 2000 Engine Instance:" using Maretron’s DSM150 or DSM250 display?

Viewed 2476 times since Thu, Jan 14, 2010

Using N2KAnalyzer, how do I recover a Maretron device?

Viewed 2146 times since Thu, Dec 22, 2011

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Invert Installation:"; what is this?

Viewed 1951 times since Tue, Jun 17, 2008

What messages (or PGNs) does the DST100 transmit?

Viewed 2744 times since Tue, Jun 17, 2008

How do I display the GPS100 local time on Maretron’s DSM150, DSM200, or DSM250 display?

Viewed 2146 times since Tue, Jun 17, 2008

What Yanmar engine models is the EMS100 compatible with?

Viewed 8381 times since Thu, Mar 27, 2014

How do I set the J2K100 configuration setting called "J1939 Source Address:" using Maretron’s DSM150 or DSM250 display?

Viewed 2747 times since Thu, Jan 14, 2010

Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.