Knowledge Base
Home » Categories » Multiple Categories

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a GPS100 configuration setting called "Cold Start GPS Engine"; what is this?

Maretron's DSM150, DSM200, and DSM250 displays have a GPS100 configuration setting called "Cold Start GPS Engine", which is used to force the GPS100 to forget what it knew the last time it acquired a lock and to start a new position fix by reacquiring all necessary information from the GPS satellites..

Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Rate of Turn Damping Period:"; what is this?
Viewed 2763 times since Thu, Jun 19, 2008
I see that Maretron’s DSM150, DSM200 and DSM250 displays have a WSO100 configuration setting called "Installation Offset Calibration..."; what is this?
Viewed 3989 times since Mon, Jul 21, 2008
How do I clear the WSO100 atmospheric pressure offset using Maretron’s DSM150 or DSM250 display?
Viewed 3541 times since Sat, Aug 2, 2008
Which Maretron products are required for me to display true wind referenced to ground speed?
Viewed 6190 times since Wed, Apr 10, 2013
Why does the SSC200 rate of turn indicate that I am turning when I am not turning?
Viewed 2584 times since Thu, Jun 19, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Operating Mode:"; what is this?
Viewed 2886 times since Thu, Jun 19, 2008
What is a GPS100?
Viewed 2721 times since Wed, Jun 25, 2008
How do I display the J2K100 generator average AC current on Maretron’s DSM150 or DSM250 display?
Viewed 3107 times since Thu, Jan 14, 2010
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Speed Calibration..."; what is this?
Viewed 2904 times since Sun, Jun 22, 2008
If the GPS100 only computes a new fix every second, why does it transmit the position 10 times per second?
Viewed 2312 times since Sun, Jun 22, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.