Knowledge Base

KB Home | Search | Glossary | Ask Question |

English

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a GPS100 configuration setting called "NMEA 2000 PGN Enable/Disable..."; what is this?

Article Number: 163 | Rating: Unrated | Last Updated: Thu, Jul 16, 2015 9:16 PM

Maretron's DSM150, DSM200, and DSM250 displays have a GPS100 configuration setting called "NMEA 2000 PGN Enable/Disable:", which is used to turn on and off specific messages that are transmitted by the GPS100.

Attachments

Attachments

There are no attachments for this article.

Related Articles

Why can’t I find a particular TLA100 tank level for display on Maretron’s DSM150, DSM200, or DSM250?

Viewed 2556 times since Fri, Jun 20, 2008

How do I display the J2K100 transmission oil pressure on Maretron’s DSM150, DSM200, or DSM250 display?

Viewed 3005 times since Thu, Jan 14, 2010

I see that Maretron’s DSM150, DSM200 and DSM250 displays have a WSO100 configuration setting called "Installation Offset Calibration..."; what is this?

Viewed 3185 times since Mon, Jul 21, 2008

Can I set the RAA100 to accept the American standard for resistance values (i.e. 240 to 33 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?

Viewed 2693 times since Fri, Jul 11, 2008

What are the operating modes of the DSM250?

Viewed 2780 times since Tue, Oct 6, 2009

Which Maretron products are required for me to display true wind referenced to ground speed?

Viewed 5173 times since Wed, Apr 10, 2013

What type of information can be viewed on Maretron’s display products, and what products are required to generate the data to be displayed?

Viewed 13062 times since Tue, Oct 25, 2011

I navigate using magnetic heading and not true heading; how do I use the SSC200 compass and Maretron’s DSM150, DSM200, or DSM250 display to view my heading in magnetic?

Viewed 3044 times since Thu, Jun 19, 2008

How do I display the TLA100, TLM100, TLM150, or TLM200 tank capacity on Maretron’s DSM150, DSM200, or DSM250 display?

Viewed 2988 times since Fri, Jun 20, 2008

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Clear Speed Calibration:"; what is this?

Viewed 2619 times since Sun, Jun 22, 2008

Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.