Knowledge Base
Home » Categories » Multiple Categories

How do I display the GPS100 Speed Over Ground (SOG) using Maretron’s DSM150, DSM200, or DSM250 display?

You display the GPS100 Speed Over Ground (SOG) information on a DSM150, DSM200, or DSM250 in the following way.

  1. Enter menu mode, scroll to "Favorite Screen Setup..." and press < Enter >
  2. Scroll to the favorite screen where you would like to view the SOG and press < Enter >
  3. Scroll to "Data:" and press < Enter >
  4. Scroll to "GPS" and press < Enter >
  5. Scroll to "Speed Over Ground" and press < Enter >
  6. Press the < Back > key three times to exit menu mode and return to the normal viewing mode.
  7. Scroll through your screens to the favorite screen you selected for SOG.
Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
How do I make the SSC200 agree with other compasses on the vessel, or, in other words, how do I align the SSC200 with the boat?
Viewed 2329 times since Mon, Jun 25, 2012
How do I set the TLA100 tank number or instance using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2672 times since Fri, Jun 20, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Invert Installation:"; what is this?
Viewed 2099 times since Tue, Jun 17, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Type:"; what is this?
Viewed 2697 times since Sun, Jun 22, 2008
What information is available from the temperature monitor (TMP100) and can be viewed on Maretron’s displays?
Viewed 3459 times since Fri, Jun 21, 2013
Why does the SSC200 rate of turn indicate that I am turning when I am not turning?
Viewed 2109 times since Thu, Jun 19, 2008
Is it possible to turn on or off SSC200 NMEA 2000 transmitted messages (or PGNs)?
Viewed 2279 times since Mon, Jun 25, 2012
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a GPS100 configuration setting called "Reset Factory Defaults"; what is this?
Viewed 2276 times since Thu, Mar 5, 2009
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Rate of Turn Zero Offset Calibration..."; what is this?
Viewed 2164 times since Sat, Jul 19, 2008
What firmware changes have taken place on the Maretron DSM250?
Viewed 2398 times since Wed, Apr 16, 2014
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.