Knowledge Base
Home » Categories » Multiple Categories

How do I display the GPS100 sunrise time on Maretron’s DSM150, DSM200, or DSM250 display?

The GPS100 doesn't actually compute and transmit the sunrise time over an NMEA 2000 network. However, the DSM200 and DSM250 receive enough information from the GPS100 (time and position) to compute the sunrise time. You display the sunrise time on a DSM150, DSM200, or DSM250 in the following way:

  1. Enter menu mode, scroll to "Favorite Screen Setup..." and press < Enter >
  2. Scroll to the favorite screen where you would like to view the sunrise time and press < Enter >
  3. Scroll to "Data:" and press < Enter >
  4. Scroll to "Time" and press < Ente r>
  5. Scroll to "Sunrise" and press < Enter >
  6. Press the < Back > key three times to exit menu mode and return to the normal viewing mode
  7. Scroll through your screens to the favorite screen you selected for sunrise time

 

Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
Why is the DST110 Speed Through Water (STW) reading different from the Speed Over Ground (SOG) reading?
Viewed 37926 times since Tue, Jun 17, 2008
How do I display the J2K100 generator average line-neutral AC RMS voltage on Maretron’s DSM150 or DSM250 display?
Viewed 2974 times since Thu, Jan 14, 2010
How do I display the GPS100 local time on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2364 times since Tue, Jun 17, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a WSO100 configuration setting called "Reset Factory Defaults"; what is this?
Viewed 1998 times since Sat, Aug 2, 2008
Why doesn’t my rudder display read hard over when the rudder is hard over?
Viewed 2825 times since Thu, Jul 10, 2008
How do I set the RAA100 configuration setting called "Gauge Resistance, + to sender" using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2714 times since Fri, Jul 11, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "NMEA 2000 PGN Enable/Disable..."; what is this?
Viewed 2026 times since Fri, Jun 20, 2008
How do I display the J2K100 engine oil pressure on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3123 times since Thu, Jan 14, 2010
What messages (or PGNs) does the GPS100 transmit?
Viewed 2342 times since Wed, Jun 25, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.