Knowledge Base
Home » Categories » Multiple Categories

How do I display the GPS100 local date on Maretron’s DSM150, DSM200, or DSM250 display?

You display the GPS100 local date information on a DSM150, DSM200, or DSM250 in the following way:

  1. Enter menu mode, scroll to "Favorite Screen Setup..." and press < Enter >
  2. Scroll to the favorite screen where you would like to view the local date and press < Enter >
  3. Scroll to "Data:" and press < Enter >
  4. Scroll to "Time" and press < Enter >
  5. Scroll to "Date Local" and press < Enter >
  6. Press the < Back > key three times to exit menu mode and return to the normal viewing mode.
  7. Scroll through your screens to the favorite screen you selected for local date.
Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
How do I display the WSO100 apparent wind on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2917 times since Thu, Jul 10, 2008
I see that Maretron’s DSM150, DSM200 and DSM250 displays have TLA100 configuration settings called "Gauge Resistance, + to sender:" and "Gauge Resistance, - to sender:"; what are these?
Viewed 2784 times since Mon, Jun 25, 2012
Why can’t I find a particular TLA100 tank level for display on Maretron’s DSM150, DSM200, or DSM250?
Viewed 2424 times since Fri, Jun 20, 2008
How do I reset the TLA100 to send the factory default messages (or PGNs)?
Viewed 1999 times since Fri, Jun 20, 2008
I see that Maretron’s DSM150, DSM200 and DSM250 displays have a WSO100 configuration setting called "Installation Offset Calibration..."; what is this?
Viewed 3038 times since Mon, Jul 21, 2008
Why I can’t find a RAA100 rudder angle for display on Maretron’s DSM150, DSM200, or DSM250?
Viewed 3345 times since Fri, Jul 11, 2008
Which Martron products work with the ALM100?
Viewed 1474 times since Wed, Jun 22, 2016
Can I set the RAA100 to accept the American standard for resistance values (i.e. 240 to 33 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2528 times since Fri, Jul 11, 2008
Can I set the RAA100 to accept the European standard for resistance values (i.e. 10 to 180 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2489 times since Thu, Jul 10, 2008
How do I set up my SMS100 address book using Maretron displays?
Viewed 2381 times since Thu, Jun 6, 2013
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.