Knowledge Base
Home » Categories » Multiple Categories

How do I display the GPS100 local time on Maretron’s DSM150, DSM200, or DSM250 display?

You display the GPS100 local time information on a DSM150, DSM200, or DSM250 in the following way:

  1. Enter menu mode, scroll to "Favorite Screen Setup..." and press < Enter >
  2. Scroll to the favorite screen where you would like to view the local time and press < Enter >
  3. Scroll to "Data:" and press < Enter >
  4. Scroll to "Time" and press < Enter >
  5. Scroll to "Time Local" and press < Enter >
  6. Press the < Back > key three times to exit menu mode and return to the normal viewing mode
  7. Scroll through your screens to the favorite screen you selected for local time
Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a J2K100 configuration setting called "Reset Factory Defaults"; what is this?
Viewed 2505 times since Thu, Jan 14, 2010
Can I set the RAA100 to accept the European standard for resistance values (i.e. 10 to 180 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2489 times since Thu, Jul 10, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "NMEA 2000 PGN Enable/Disable..."; what is this?
Viewed 2026 times since Fri, Jun 20, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Rate of Turn Zero Offset Calibration..."; what is this?
Viewed 2187 times since Sat, Jul 19, 2008
How do I set a "Device Instance" for a Maretron sensor using the DSM250?
Viewed 2946 times since Tue, Sep 1, 2009
What information does the GPS100 provide?
Viewed 2363 times since Sun, Jun 22, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Number:"; what is this?
Viewed 2619 times since Thu, Jun 19, 2008
How do I display the GPS100 Speed Over Ground (SOG) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2136 times since Tue, Jun 17, 2008
Can I use the DCR100 to turn on my Marine Audio Amplifier ?
Viewed 1366 times since Tue, Jul 19, 2016
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a J2K100 configuration setting called "J1939 Diagnostic Messages:"; what is this?
Viewed 2718 times since Thu, Jan 14, 2010
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.