Knowledge Base

KB Home | Search | Glossary | Ask Question |

English

What is the maximum rate at which the SSC200 will transmit heading from the NMEA 0183 port?

Article Number: 130 | Rating: Unrated | Last Updated: Mon, Jul 13, 2015 4:11 AM

By default, the SSC200 transmits heading from the NMEA 0183 interface ten times per second. This can be changed to 40 times per second in one of two ways: 1) using Maretron's DSM150, DSM200, or DSM250 display (please see the respective display's user's manual), or 2) sending the SSC200 a proprietary NMEA 0183 message via a terminal emulator (please see the SSC200 user's manual). In order to truly transmit heading 40 times per second, the baud rate will need to be changed 38,400 baud.

Attachments

Attachments

There are no attachments for this article.

Related Articles

I see the SSC200 uses the NMEA 0183 identifier II (i.e., the two letters following the $ of an NMEA 0183 sentence); is it possible to change the identifier to some other value?

Viewed 2469 times since Tue, Jun 17, 2008

Using N2KAnalyzer, how do I recover a Maretron device?

Viewed 4586 times since Thu, Dec 22, 2011

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Variation Source:"; what is this?

Viewed 2831 times since Thu, Jun 19, 2008

Why does the SSC200 pitch not read zero when the vessel is flat in the water?

Viewed 2296 times since Thu, Jun 19, 2008

What information does the SSC200 compass provide?

Viewed 3066 times since Wed, Jun 18, 2008

How do I display the SSC200 roll angle on Maretron’s DSM150, DSM200, or DSM250 display?

Viewed 2585 times since Thu, Jun 19, 2008

I navigate using true heading and not magnetic heading; how do I use the SSC200 compass and N2KView software to view my heading in true?

Viewed 4918 times since Fri, Jul 18, 2008

I see that Maretron’s DSM150 and DSM250 displays have a SSC200 configuration setting called "NMEA 2000 PGN Enable/Disable..."; what is this?

Viewed 2612 times since Thu, Jun 19, 2008

Why does the SSC200 rate of turn indicate that I am turning when I am not turning?

Viewed 2584 times since Thu, Jun 19, 2008

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Rate of Turn Zero Offset Calibration..."; what is this?

Viewed 2670 times since Sat, Jul 19, 2008

Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.