Knowledge Base
Home » Categories » Multiple Categories

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Reset Factory Defaults"; what is this?

Maretron's DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Reset Factory Defaults", which is used to return the SSC200 to its factory settings. Resetting the SSC200 erases the deviation table, clears the installation offset, resets the installation orientation to normal, sets the variation source back to "NMEA 0183 or NMEA 2000", resets the rate of turn damping period, clears rate of turn calibration settings, returns PGN enable/disable back to the default, and returns all NMEA 0183 settings back to the factory defaults.

Attachments (2) Attachments
Related Articles RSS Feed
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Clear Speed Calibration:"; what is this?
Viewed 2483 times since Sun, Jun 22, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Rate of Turn Zero Offset Calibration..."; what is this?
Viewed 2164 times since Sat, Jul 19, 2008
Can I set the RAA100 to accept the American standard for resistance values (i.e. 240 to 33 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2497 times since Fri, Jul 11, 2008
How do I display the J2K100 engine hours on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2862 times since Thu, Jan 14, 2010
How close can I install wires to the SSC200 before I start adversely affecting the compass?
Viewed 2193 times since Mon, Jul 21, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Number:"; what is this?
Viewed 2588 times since Thu, Jun 19, 2008
Can I set the RAA100 to accept the European standard for resistance values (i.e. 10 to 180 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2462 times since Thu, Jul 10, 2008
How do I configure a channel on the TMP100 using Maretron’s DSM250?
Viewed 2603 times since Fri, Jun 11, 2010
Can I do a custom calibration for non-standard resistance sensors or odd shaped tanks?
Viewed 2344 times since Thu, Jun 19, 2008
How do I reset the J2K100 to send the factory default NMEA 2000 messages (or PGNs)?
Viewed 2615 times since Thu, Jan 14, 2010
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.