Knowledge Base
Home » Categories » Navigation Instruments » SSC200

I see the SSC200 uses the NMEA 0183 identifier II (i.e., the two letters following the $ of an NMEA 0183 sentence); is it possible to change the identifier to some other value?

Yes, it is possible to change the identifier that the SSC200 transmits as part of NMEA 0183 sentences. Please refer to the user's manual for instructions on how to make this change.

Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
Is it possible to turn on or off SSC200 NMEA 2000 transmitted messages (or PGNs)?
Viewed 2078 times since Mon, Jun 25, 2012
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Reset Factory Defaults"; what is this?
Viewed 2256 times since Mon, Jul 21, 2008
How do I reset the SSC200 to send the factory default NMEA 2000 messages (or PGNs)?
Viewed 1992 times since Thu, Jun 19, 2008
How do I make the SSC200 agree with other compasses on the vessel, or, in other words, how do I align the SSC200 with the boat?
Viewed 2154 times since Mon, Jun 25, 2012
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Variation Source:"; what is this?
Viewed 2208 times since Thu, Jun 19, 2008
Why is the SSC200 compass better than other marine compasses that use fluxgate technology?
Viewed 3345 times since Thu, Jun 19, 2008
Why does the heading coming from the SSC200 appear to be in error?
Viewed 2359 times since Thu, Jun 19, 2008
I navigate using magnetic heading and not true heading; how do I use the SSC200 compass and N2KView software to view my heading in magnetic?
Viewed 3163 times since Thu, Jun 19, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Rate of Turn Zero Offset Calibration..."; what is this?
Viewed 2008 times since Sat, Jul 19, 2008
What is the maximum rate at which the SSC200 will transmit heading from the NMEA 2000 port?
Viewed 1650 times since Thu, Jun 19, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.