Knowledge Base

KB Home | Search | Glossary | Ask Question |

English

What is the baud rate of the SSC200 NMEA 0183 port?

Article Number: 122 | Rating: Unrated | Last Updated: Mon, Jul 13, 2015 4:03 AM

The default baud rate of the SSC200 NMEA 0183 port is 4800 baud. This can be changed to 38,400 baud if desired.

Attachments

Attachments

There are no attachments for this article.

Related Articles

How do I set a "Device Instance" for a Maretron sensor using the DSM250?

Viewed 3774 times since Tue, Sep 1, 2009

I navigate using true heading and not magnetic heading; how do I use the SSC200 compass and N2KView software to view my heading in true?

Viewed 5129 times since Fri, Jul 18, 2008

Can Maretron devices be displayed on a Raymarine Seatalk NG network?

Viewed 10516 times since Wed, Feb 25, 2015

I see the SSC200 uses the NMEA 0183 identifier II (i.e., the two letters following the $ of an NMEA 0183 sentence); is it possible to change the identifier to some other value?

Viewed 2603 times since Tue, Jun 17, 2008

What information does the SSC200 compass provide?

Viewed 3194 times since Wed, Jun 18, 2008

I navigate using magnetic heading and not true heading; how do I use the SSC200 compass and N2KView software to view my heading in magnetic?

Viewed 4488 times since Thu, Jun 19, 2008

What is magnetic variation?

Viewed 3060 times since Wed, Jun 18, 2008

Which Maretron products are required for me to display true wind referenced to ground speed?

Viewed 6640 times since Wed, Apr 10, 2013

What firmware changes have taken place on the Maretron SSC200?

Viewed 4776 times since Mon, May 16, 2011

Why is the SSC200 compass better than other marine compasses that use fluxgate technology?

Viewed 4278 times since Thu, Jun 19, 2008

Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.