Knowledge Base
Home » Categories » Multiple Categories

How do I display the SSC200 pitch on Maretron’s DSM150, DSM200, or DSM250?

You display the SSC200 pitch on a DSM150, DSM200, or DSM250 in the following way:

  1. Enter menu mode, scroll to "Favorite Screen Setup..." and press < Enter >
  2. Scroll to the favorite screen where you would like to view pitch and press < Enter >
  3. Scroll to "Data:" and press < Enter >
  4. Scroll to "Vessel" and pressĀ < Enter >
  5. Scroll to "Pitch" and pressĀ < Enter >
  6. Press the < Back > key three times to exit menu mode and return to the normal viewing mode
  7. Scroll through your screens to the Favorite Screen you selected for pitch
Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
How do I display the GPS100 twilight PM time on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2174 times since Tue, Jun 17, 2008
How do I display the SSC200 magnetic heading on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2728 times since Tue, Jul 22, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Speed Calibration..."; what is this?
Viewed 2487 times since Sun, Jun 22, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a GPS100 configuration setting called "NMEA 2000 PGN Enable/Disable..."; what is this?
Viewed 2140 times since Tue, Jun 17, 2008
How do I display the J2K100 engine fuel pressure on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2647 times since Thu, Jan 14, 2010
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Rate of Turn Zero Offset Calibration..."; what is this?
Viewed 2189 times since Sat, Jul 19, 2008
How do I reset the GPS100 to send the factory default NMEA 2000 messages (or PGNs)?
Viewed 2462 times since Tue, Jun 17, 2008
How do I reset the TLA100 to send the factory default messages (or PGNs)?
Viewed 1999 times since Fri, Jun 20, 2008
How do I display the J2K100 engine boost pressure on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3072 times since Thu, Jan 14, 2010
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Reset Factory Defaults"; what is this?
Viewed 2477 times since Mon, Jul 21, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.