Knowledge Base
Home » Categories » Multiple Categories

How do I display the SSC200 roll angle on Maretron’s DSM150, DSM200, or DSM250 display?

You display the SSC200 roll angle on a DSM150, DSM200, or DSM250 in the following way:

  1. Enter menu mode, scroll to "Favorite Screen Setup..." and press < Enter >
  2. Scroll to the favorite screen where you would like to view roll and press < Enter >
  3. Scroll to "Data:" and press < Enter >
  4. Scroll to "Vessel" and press < Enter >
  5. Scroll to "Roll" and press < Enter >
  6. Press the < Back > key three times to exit menu mode and return to the normal viewing mode
  7. Scroll through your screens to the Favorite Screen you selected for roll
Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
Which Maretron products are required for me to display true wind referenced to ground speed?
Viewed 4728 times since Wed, Apr 10, 2013
How do I display the J2K100 engine fuel rate on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2950 times since Thu, Jan 14, 2010
How do I show simple bilge information on Mareton’s DSM150 or DSM250 displays?
Viewed 3381 times since Sat, Apr 27, 2013
I navigate using true heading and not magnetic heading; how do I use the SSC200 compass and N2KView software to view my heading in true?
Viewed 4008 times since Fri, Jul 18, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Reset Factory Defaults"; what is this?
Viewed 1939 times since Fri, Jun 20, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Installation Offset Calibration?"; what is this?
Viewed 2061 times since Thu, Jun 19, 2008
How do I display the J2K100 transmission gear on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2429 times since Thu, Jan 14, 2010
How do I display the GPS Course Over Ground (COG) using Maretron’s DSM150 or DSM250 display?
Viewed 3120 times since Tue, Jun 17, 2008
What information is available from the J1939 to NMEA 2000 Bridge (J2K100) and can be viewed on Maretron’s displays?
Viewed 2321 times since Mon, Jun 24, 2013
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Invert Installation:"; what is this?
Viewed 1989 times since Tue, Jun 17, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.