Knowledge Base
Home » Categories » Multiple Categories

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Installation Offset Calibration?"; what is this?

Maretron'sDSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Installation Offset Calibration...", which is used to electronically align the compass with the vessel. Although there is an arrow on the compass label, it is difficult to exactly align the compass with the vessel during installation. This configuration setting allows the compass to be precisely aligned with the vessel.

Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
Can I turn On and Off loads connected to the DCR100 using the DSM150 or DSM250?
Viewed 2576 times since Thu, May 5, 2011
How do I display the GPS100 twilight AM time on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 1969 times since Tue, Jun 17, 2008
How do I display the J2K100 engine percent load on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2588 times since Thu, Jan 14, 2010
How do I set the TLA100 configuration setting called "Gauge Resistance, + to sender:" using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2281 times since Mon, Jun 25, 2012
How do I make the SSC200 agree with other compasses on the vessel, or, in other words, how do I align the SSC200 with the boat?
Viewed 2204 times since Mon, Jun 25, 2012
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Number:"; what is this?
Viewed 2439 times since Thu, Jun 19, 2008
How do I display the TLA100 tank remaining on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2356 times since Fri, Jun 20, 2008
Can I set the TLA100 to accept the American standard for resistance values (i.e. 240 to 33 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 1991 times since Fri, Jun 20, 2008
How do I reset the SSC200 to send the factory default NMEA 2000 messages (or PGNs)?
Viewed 2043 times since Thu, Jun 19, 2008
What firmware changes have taken place on the Maretron SSC200?
Viewed 3203 times since Mon, May 16, 2011
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.