Knowledge Base

KB Home | Search | Glossary | Ask Question |

English

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Magnetic Deviation Status?"; what is this?

Article Number: 100 | Rating: Unrated | Last Updated: Mon, Jul 13, 2015 12:10 AM

Maretron's DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Magnetic Deviation Status...", which is used to display information about the deviation table that was stored within the compass when the compass was last calibrated to account for magnetic deviation.

Attachments

Attachments

There are no attachments for this article.

Related Articles

Which NMEA 0183 sentences does the SSC200 transmit?

Viewed 3605 times since Tue, Jun 17, 2008

How do I set the TLA100 configuration setting called "Gauge Resistance, - to sender" using Maretron’s DSM150, DSM200, or DSM250 display?

Viewed 3737 times since Fri, Jun 20, 2008

What Maretron products are recommended for displaying Yanmar engine information?

Viewed 5277 times since Sat, Sep 5, 2009

Why I can’t find a RAA100 rudder angle for display on Maretron’s DSM150, DSM200, or DSM250?

Viewed 3962 times since Fri, Jul 11, 2008

How do I show comprehensive bilge information on Maretron’s DSM150 or DSM250 displays?

Viewed 9019 times since Thu, May 30, 2013

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a WSO100 configuration setting called "Reset Factory Defaults"; what is this?

Viewed 2698 times since Sat, Aug 2, 2008

I navigate using magnetic heading and not true heading; how do I use the SSC200 compass and N2KView software to view my heading in magnetic?

Viewed 4546 times since Thu, Jun 19, 2008

How do I display the J2K100 generator average AC frequency on Maretron’s DSM150 or DSM250 display?

Viewed 3598 times since Thu, Jan 14, 2010

How do I configure a channel on the SIM100 using Maretron’s DSM250 Display?

Viewed 2784 times since Tue, Sep 1, 2009

How do I calibrate the SSC200 to account for magnetic deviation?

Viewed 3182 times since Sat, Jul 19, 2008

Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.