Maretron support knowledge base
Maretron Knowledge Base

Knowledgebase Home > NMEA 2000 Cables and Connectors > Powertaps | Glossary | Favorites | Contact Knowledgebase Home | Glossary | Favorites | Contact
Search the Knowledgebase Browse by Category
View Articles by Category
There are no sub categories
Powertaps rss button
There were 3 articles found in this category:
  1. questionWhat are the weights and dimensions of Maretron products?


  2. questionThe Micro PowerTap has five wires; how should I connect them to my 12V DC?
    The Micro/Mid Powertap has five individual wires on the opposite end of the tee connector. Connect the white and brown wire to a 4 to 6 amp in-line fuse. Connect your in-line fuse to a 9-16 Volt DC source. Then connect the gray, blue, and black wires to DC ground. Check your bus power by connect ...

  3. questionHow is the Mini Powertap wired?
    The Mini Powertap has 4 connection points. There are two 5-pin connectors on opposite sides of the powertap that are used as the NMEA 2000 bus connections (marked "BUS"), there is a 4-pin connector on the bottom of the powertap that is used as the power connection (marked "Supply"), and there is ...


Powered by Interspire Knowledge Manager Knowledgebase Software