What firmware changes have taken place on the Maretron J2K100?

Update your device today using the N2KAnalyzer software tool.

1.0.13.2 (2011-10-25)

-  Corrects an issue with controlling multiple Dometic Icemakers/AC’s on an NMEA 2000 network.

1.0.11   1.0.11 (2010-11-18)
- Add programmable damping for Engine Speed.
- Add programmable damping for Fuel Rate.

1.0.10  (2010-08-17)
- Improvements to manufacturing.

1.0.9   (2010-03-18)
- Added support for use as a gateway for a Dometic (MarineAir Elite and CruiseAir Q-Logic)Air Conditioner or a Dometic (Eskimo) Icemaker.

1.0.7   (2009-03-04)

            - Added support for labeling so that the device can easily be identified with a user-programmable string.

            - Added ability to configure transmission periods for periodic PGN’s 

            1.0.6  (2008-10-02)

- Add support for displaying node address of J1939 devices in the J2K100 configuration screens

- Corrected a problem that occurred when a ISO request was received on the J1939 port, causing the J2K100 to behave erratically with certain J1939 engines (notably Caterpillar)

1.0.5  (2008-03-03)

- Fixed problem where the device tried to transmit a PGN before it had acquired a node address

- Updated  conversion ratio of engine fuel pressure to match NMEA2000 v1.2

1.0.4  (2007-12-10)

- Validates J1939 data and does not transmit it (instead reports “Data Not Available”) if it is out of allowable range in the J1939 message

- In the Engine Parameters, Dynamic PGN (127489), ensure that all Discrete Warning Status bits are set to “0”

1.0.3 (2007-11-15)

- Supports display of voltage in all of the different ways J1939 engines may report it

1.0.1 (2006-04-13)

- Initial public release