Maretron Support Knowledge Base

Knowledgebase Home > PC Software/Interfacing > USB100 | Glossary | Favorites | Contact

Search the Knowledgebase	Browse by Category
[Advanced Search]

View Articles by Category

There are no sub categories

USB100

NMEA 2000/USB Gateway

There were 8 articles found in this category:

What software changes have been made to GWUtilities and USB100 drivers?
Changes in the USB100 Drivers and Support Software version 2.1 from version 2.0a: - Support has been added for the following operating versions of Microsoft Windows: · Windows XP 64-bit · Windows Vista 64-bit · Windows 7 32-bit · ...
Does Maretron make a waterproof USB cable for connecting the USB100 to a computer?
No, Maretron does not make a waterproof USB cable for connection between the USB100 and a computer. However, a waterproof cable can be built using the following parts, which can be ordered from http://www.digikey.com/ A-KAB-USBB-MS-1M-R A-USBPA-R A-USBPA-HOOD-R
Does the USB100 convert NMEA 2000 engine PGNs to NMEA 0183 sentences?
Yes, the USB100 converts some of the NMEA 2000 engine PGN information into NMEA 0183 sentences. Please refer to the document entitled “USB100 Engine Sentences.pdf”, which can be found below in the Attachments section.
Does the USB100 work with MAC OSX?
The USB100 uses the standard CDCACM driver for Mac based OSX computers.
What are the Voltage specifications for each Maretron device?
Maretron Model Operating Voltage Engine/Battery Interface USB100 9 to 16 Volts DSM250 9 to 32 Volts DSM200 9 to 16 Volts ALM100 9 to 32 Volts WSO100 9 to 16 Volts SSC200 9 to 16 Volts GPS100 9 to 16 Volts GPS200 9 to 32 Volts DST100 9 to ...
What firmware changes have taken place on the Maretron USB100?
USB100 Firmware Versions: 1.8.3 (2009-03-20) - Added translation for 130576 (Small Craft Status) to NMEA 0183 XDR sentence for trim tabs 1.8.2 (2008-03-10) - Reduced network load when searching for devices on powerup 1.8.1 (2008-03-03) - Fixed problem where the device tried to transmit ...
Does Maretron have Linux driver for the USB100?
The USB100 is compatible with Linux using standard CDCACM drivers available withing the OS. Refer to the following link for details:http://www.jungo.com/st/drivercore/cdc_acm_driver.html
My USB100 interface is in use by the navigational program on my PC. Can N2Kview interface with that same com port?
The USB100 can only be in use by one program at a time. The remedy is a USB100 will be in use by your navigational software. A second USB100 gateway will provide data to the vessel monitoring program, such as N2KView.

HOME

Site Home